Dell PowerVault NX1950 User Manual

Page 24

Deployment Guide

If you selected Configure RAID, configure the RAID with one of the

following options:
• Click

Go to Advanced Wizard at the top left of the page and

follow the prompts.

• Select a RAID level and click

Continue.

NOTE:

Select RAID1 to ensure adequate redundancy for the boot disk.

The RAID configuration summary appears.

Click Continue.
The following message appears:

All existing virtual disk(s) on this controller

will be deleted and all data will be lost

Click OK to continue.

The

Select an Operating System to Install window appears.

10 To set up a new boot partition, select the appropriate file system and size

for your partition and click

Continue.

NOTICE:

If the hard drive has a partition, the Confirm to delete partition window

appears. Click Continue. Dell Systems Build and Update Utility deletes all existing

partitions on the hard drive.

NOTE:

For maximum system security, Dell recommends selecting NTFS-NT

file system.

The Network Adapter(s) configuration window appears.

11 Select one of the following options and click Continue:

• Obtain IP address from the DHCP server.
• Specify an IP address.
The

Enter Configuration Information: Microsoft Windows Server 2003

x64 Edition window appears.

12 Enter your system information in the appropriate fields, and click Continue.

NOTE:

If you leave any field blank, Windows Setup prompts you later for this

information.

NOTE:

To provide more configuration information, click the Advanced tab in

the top-right corner.