Dell PowerVault NX1950 User Manual

Page 23

Deployment Guide

If you are using the Dell Systems Build and Update Utility on your system

for the first time, perform the following steps:

When prompted, click the appropriate language for your system.
The

Dell Software License Agreement window appears. Read the

information carefully.

If you agree with all of the information, click Accept to continue.
If you do not agree with all the information, click Decline. Your system

restarts, and you will not able to complete the operating system

installation.

5 Click Server Setup to install the operating system.

The

Set the Date and Time window appears.

6 Select the appropriate date, time, and time zone, and click Continue.
7 Select Microsoft Windows Server 2003 x64 Edition.

NOTE:

Select Microsoft Windows Server

2003 x64 Edition.

NOTE:

Since the product identification (PID) is included on the operating

system media, providing your PID is not required. You are only prompted to

enter a PID during the Server Administrator installation if you use

Dell OpenManage 5.0 or earlier.

8 Click Continue.

The

Configure the Hard Drive for Microsoft window appears.

9 The Configure or Skip RAID window appears. Perform the following

steps:

Select one of the following options, and then click Continue:
• Configure RAID
• Skip RAID configuration

NOTE:

Your system was pre-configured with hardware RAID1 using both the

internal hard disk drives, and this is the only supported hardware

configuration for your system.

If you selected Skip RAID configuration, go to step 10.