Dell PowerEdge M610 User Manual
Page 129
About Your System
129
PCI BIOS failed to
install.
Faulty or improperly
installed mezzanine card.
Reseat the mezzanine card.
Cards" on page 217. If the
problem persists, see
Plug & Play
Configuration
Error.
Error encountered in
initializing PCI device;
faulty blade board.
Set the NVRAM_CLR
jumper to "on" and reboot
the blade. See
the jumper location.
Check for a BIOS update. If
the problem persists, see
PCIe Training
Error: Expected
Link Width is x',
Actual Link Width
is x
Faulty or improperly
installed PCIe card in the
specified slot.
Reseat the PCIe card in the
specified slot number. See
Cards" on page 321. If the
problem persists, see
ROM bad checksum =
address
Expansion card improperly
installed or faulty.
Ensure that the expansion
card is installed properly. See
BIOS Update
Attempt Failed.
BIOS remote update
failed.
Retry the BIOS update. If
problem persists, see
Invalid
configuration
information -
please run SETUP
program
CMOS checksum failure. Run the System Setup
program and review the
current settings. See "Using
Table 1-27. Blade Messages
(continued)
Message
Causes
Corrective Actions