Dell Premium Remote Control - Manual (Page 7)

6. The Dell Premium Remote Control remains in Learning mode so you can continue adding functions to different buttons by repeating steps 3, 4, 5.
7. Press CLEAR to exit the Learning mode.
To delete a learned button function, perform the following steps:
1. Press and hold the TV button on the remote control.
2. Press and hold the CLEAR button until the TV button flashes, usually about three seconds.
3. Release both buttons. The TV button turns on indicating that the remote control is now in the Clear Learned Function mode.
4. Press and release the button where learning is to be cleared. The TV button blinks off then back on indicating that the function was cleared successfully.
5. Repeat Steps 1 through 4 for any additional learned functions you would like to clear.
6. Press the CLEAR button to return the remote control to normal operation.
To delete all learned functions at once, perform the following steps:
1. Press the TV button on the remote control to make sure the remote control is in the correct mode.
2. Press and hold the CLEAR button on the Dell Premium Remote Control.
3. Press and hold the ON/OFF button. The TV button light turns off for three seconds, flashes, turns on, and then off.
4. Release both buttons. The TV button turns on.
5. Press the TV button to delete all learned functions. The Dell Premium Remote Control automatically exits this clearing mode.
Please read all restrictions and disclaimers .
Back to Contents Page
NOTE: If all device mode buttons flash 4 times, the function was not learned. Try again by starting with Step 1.
NOTE: If an invalid button is pressed, the TV mode button flashes 4 times, the selected component button stays on, and the remote control
remains in Clear Learned Function mode. Repeat Step 4 to continue the clearing process.
NOTE: Pressing the CLEAR button while in this mode will not delete the learning functions, but it will exit this delete mode.