Dell PowerEdge R410 - Manual (Page 43)

About Your System
43
DIMM
configuration on
each CPU should
match.
Invalid memory
configuration on a
dual-processor system.
The memory module
configuration for each
processor must be identical. Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module Installation
Guidelines" on page 119.
Embedded NIC x and
NIC y:
OS NIC=
|DISABLED>,
Management
Shared NIC=
|DISABLED>
The OS NIC interface is set
in BIOS. The Management
Shared NIC interface is set
in management tools. Check the system
management software or the
System Setup program for
NIC settings. If a problem is
indicated, see
"Troubleshooting a NIC" on
page 147.
Error 8602 -
Auxiliary Device
Failure. Verify
that mouse and
keyboard are
securely
attached to
correct
connectors.
Mouse or keyboard cable is
loose or improperly
connected. Reseat the mouse or
keyboard cable.
Defective mouse or keyboard. Ensure that the mouse or
keyboard is operational. See
"Troubleshooting a USB
Device" on page 146.
Gate A20 failure Faulty keyboard controller;
faulty system board. See "Getting Help" on
page 167.
Invalid
configuration
information -
please run SETUP
program.
An invalid system
configuration caused a
system halt. Run the System Setup
program and review the
current settings. See "Using
the System Setup Program
and UEFI Boot Manager" on
page 57.
Table 1-3. System Messages (continued)
Message Causes Corrective Actions
book.book Page 43 Tuesday, March 31, 2009 5:26 PM