Dell PowerEdge R410 - Manual (Page 118)

118
Installing System Components
3 To disconnect the RAID battery cable from the connector on the system
board, press the tab on the RAID battery cable connector, and gently
pull the cable connector out of the connector on the system board.
See Figure 3-20.
4 Pull back gently on the two tabs holding the RAID battery and lift the
RAID battery from the battery carrier. See Figure 3-20.
Figure 3-20. Removing and Installing the RAID Battery
Installing the RAID Battery
1 Insert the RAID battery into the battery carrier until it locks into place.
See Figure 3-20.
2 Connect the battery cable to the connector on the system board. See
Figure 7-1.
3 Close the system. See "Closing the System" on page 83.
1 RAID battery 2 battery cable connector
3 battery carrier tabs (2) 4 battery carrier
3
2
4
1
book.book Page 118 Tuesday, March 31, 2009 5:26 PM