Dell PowerEdge R410 - Manual (Page 120)

120
Installing System Components
• For Memory Mirroring or Advanced ECC Mode, the two sockets furthest
from the processor are unused and memory modules are installed
beginning with socket A1 or B1 and proceeding with socket A2 or B2.
• Advanced ECC Mode requires memory modules that use x4 or x8 DRAM
device widths.
• The memory speed of each channel depends on the memory
configuration:
– For single or dual-rank memory modules:
• One memory module per channel supports up to 1333 MHz.
• Two memory modules per channel supports up to 1067 MHz.
– For quad-rank memory modules:
• One memory module per channel supports up to 1067 MHz.
• Two memory modules per channel are limited to 800 MHz,
regardless of memory module speed.
• If quad-rank memory modules are mixed with single- or dual-rank
modules, the quad-rank modules must be installed in the sockets with the
white release levers.
• If memory modules with different speeds are installed, they will operate at
the speed of the slowest installed memory module(s).
Mode-Specific Guidelines
Three memory channels are allocated to each processor. The number of
channels used and the allowable configurations depend on the memory mode
selected.
Advanced ECC (Lockstep) Mode Support
In this configuration, the two channels closest to the processor are combined
to form one 128-bit channel. This mode supports Single Device Data
Correction (SDDC) for both x4- and x8-based memory modules. Memory
modules must be identical in size, speed, and technology in
corresponding slots.
book.book Page 120 Tuesday, March 31, 2009 5:26 PM