Cabletron Systems SEHI-32 - Manual (Page 38)

INSTALLATION
Page 3-5
3.2.3 Rack Mounting the SEHI
Refer to Figure 3-4 and perform these steps to install the SEHI in a
19-inch rack.
1. Remove four cover screws (two from each side) located along the
front edges of each side of the SEHI.
2. Using the four cover screws removed in step 1, attach the rack
mounting brackets to each end of the SEHI.
Figure 3-4. Installing the Rack Mount Brackets
3. With the mounting brackets installed, position the SEHI between
the vertical frame members of the 19-inch rack and fasten it
securely with the mounting screws as shown in Figure 3-5.
Figure 3-5. Installing the SEHI in the Rack
Screws (4)
Wall/Rack Mounting
Brackets (2)
HubSTACK 10BASE-T HUB WITH LANVIEW®
SEHI-24
Screws (4)
19-Inch Rack
HubSTACK 10BASE-T HUB WITH LANVIEW®
SEHI-24