Compaq Graphical User Interface mar345 - Manual (Page 5)

mar345 Program Manual 5
______________________________________________________________________________________
2. Running mar345
2.1 Command Line
The program mar345 should be started by just typing "mar345". The program, however,
understands the following command line options:
mar345 [−h] [−colors N] [−def XXXX] [−host HOST] [−keep]
[−more N] [−noxf] [−port PORT] [−setd]
The command line options are:
−h Print a usage summary
−colors N Use N colors for drawing images.
Default: take N from configuration file.
−def XXXX When starting the program, go to scanmode XXXX where
XXXX is 1200, 1600, 1800, 2000, 2300, 2400, 3000 or 3450.
Default: stay in current scan mode.
−host HOST Connect to host HOST.
Default: take HOST from configuration file (usually 192.0.2.1)
−keep Spiral images will be saved on disk.
Default: do not produce spiral files, only transformed images.
−more N Log output level with N=0, 1, 2 or 3.
Use more > 0 only in case of hardware problems.
Default: N=0 (compact output)
−noxf Spiral images will not be transformed into Cartesian images.
The program then requires much less memory, but images
cannot be displayed.
Default: Do transform spiral images.
−port PORT Connect to host HOST via socket port PORT.
Default: take PORT from configuration file (usually 4441)
−setd The user may redefine the distance detector to crystal from
within the program.
Default: Redefining the distance is disallowed..