Compaq MP1400 - Manual (Page 66)

B-6 Agency Regulatory Notices
Writer: M. Silvetti Saved by: Marianne Silvetti Saved date: 05/16/00 5:15 PM
Part Number: 177284-001 File name: DAppB.doc
Power Cords
The projector power supply is provided with Automatic Line
Switching (ALS). This feature allows the projector to operate on
input voltages between 100-240V.
The power cord set (flexible cord or wall plug) received with the
projector meets the requirements for use in the country where you
purchased the equipment.
If you need to obtain a power cord for a different country, you
should purchase a power cord that is approved for use in that
country.
The power cord must be rated for the product and for the voltage
and current marked on the product’s electrical ratings label. The
voltage and current rating of the cord should be greater than the
voltage and current rating marked on the product. In addition, the
diameter of the wire must be a minimum of 0.75 mm
2 or 18AWG,
and the length of the cord must be between 6 feet (1.8 m) and
12 feet (3.6 m). If you have questions about the type of power
cord to use, contact your Compaq authorized service provider.
A power cord should be routed so that it is not likely to be walked
on or pinched by items placed upon it or against it. Particular
attention should be paid to the plug, electrical outlet, and the
point where the cord exits from the product.