Replacing the projector lamp module – Compaq MP1400 User Manual
Page 52
5-4
MP1400 Microportable Projector
Part Number: part number 177284-001 - Writer: Marianne Silvetti - Saved by: Marianne Silvetti
Pages: 6 Words: 970 Saved date: 05/12/004:34 PM File Name: Chap5.doc
Replacing the Projector Lamp Module
When the projector lamp reaches its end of life, it may pop when it
burns out. The lamp will need to be replaced before the projector
can be used again.
!
WARNING:
When the lamp reaches its end of life, it may pop
or rupture. To reduce the risk of personal injury, be careful
when removing the lamp cover as broken glass may be
present. Never open the lamp cover while the projector is
operating or when the lamp is hot.
The projector will alert you when the lamp approaches its failure
mode or end of life. When the message “Lamp May Fail Soon -
Replacement Suggested” displays on the projection screen, you
should change the lamp as soon as possible.
Contact your local Compaq authorized dealer, seller, or reseller to
purchase a replacement lamp or have the lamp changed. To locate a
reseller near you, call 1-800-AT-COMPAQ. To purchase the lamp
directly from Compaq, visit the Compaq web site at