Char-Broil RED 463250211 - Manual (Page 19)

11
19
12
Insert hinge pin on bottom of door into hole in bottom shelf. Press upper hinge pin in front brace, align hinge hole on top of
Attach door handle to door using two #10-24x3/8” screws, 5mm lock washers and 5mm flat washers, shown A.
door, and release hinge pin into door.
Hinge pin
on bottom
of door
Top of
door
PRESS
Door
Connect each of the wires from main burner electrodes into the back of the Electronic Ignition Module. Total (2) connections.
Connect the two wires [(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).
Total (2) connections.
1
(a)
(b)
2
#10-24x3/8” screw
Door
Door handle
5mm lock washer
5mm flat washer
A