Cabletron Systems HSIM-G01 - Manual (Page 29)

Gigabit Ethernet Configuration Screen
HSIM-G01/G09 User’s Guide 4-3
Figure 4-2 Gigabit Ethernet Configuration Screen
The following defines each field of the Gigabit Ethernet Configuration
screen.
Port X (Read-Only)
The port or interface number on the host platform in which the HSIM-G
is installed.
Port Type (Read-Only)
Displays the type of interface (HSIM-G01 or HSIM-G09) installed in the
HSIM-G.
Figure 4-2 shows an HSIM-G01 installed.
Link Status (Read-Only)
Indicates whether or not there is a physical connection from this port to
another gigabit Ethernet port. One of the following values displays:
• Link - There is a link signal present and a valid physical connection to
another device.
• No Link - There is no link signal present and no valid physical
connection to another device.
• NA - The port has not completed its auto-negotiation.
Firmware Revision: XX.XX.XX
Gigabit Ethernet HSIM 1 Configuration
Port Type
Link Status
Current Oper. Mode
Desired Oper. Mode
Advertised Ability
BOOTPROM Revision: XX.XX.XX
HSIM-G01
Link
1000Base-XFD
[Auto-Negotiation]
[1000Base-XFD] [Enabled]
Module Type: 6E133-25
Slot Number: X
EXIT
2398_GigaConfig
Port X
6E133-25 LOCAL MANAGEMENT
Event Message Line
RETURN SAVE