970 series, On-off float valve, Model – Ames Fire & Waterworks 972GS Stainless Steel On-Off Float Valve (4 and Smaller) User Manual
Page 2: 4” and smaller)
01/06
970 Series
Model
8550 Hansen Road
•
Houston, Texas 77075
•
(Ph) 713.943.0688
•
(Fx) 713.944.9445
•
www.amesfirewater.com
972
672
ON-OFF FLOAT VALVE
(4” and Smaller)
Installation Guidelines
• Prior to installation, flush line to remove debris.
• Install valve horizontally “in line” (cover facing UP), so flow arrow matches flow through the line. Avoid
installing valves 6” and larger vertically. Consult factory prior to ordering if installation is other than
described.
• Install inlet and outlet isolation valves. NOTE: When using butterfly valves, insure disc does not contact
control valve. Damage or improper valve seating may occur.
• Provide adequate clearance for valve servicing and maintenance.
• Install pressure gauge to monitor valve inlet pressure.
• Provide adequate drain for cover chamber discharge. Consult “Valve Cover Capacity” chart on appropriate
main valve Engineering Bulletin.
• If On-Off Float Pilot is remotely mounted it should be field connected with 3/8” minimum copper tubing
in accordance with factory piping schematic.
• Float Pilot, Rods, and Ball should be mounted in a field installed “stilling well” for protection against
surface turbulence and interference.
• Additional 12” Float Rods available. Consult Factory.
Other AMES Float Control Valves
972-19 / 672-19
On-Off Float Control Valve (6” & larger)
972-20 / 672-20
On-Off Float Control Valve with Pressure Sustaining Feature
979 / 679
Modulating Float Control Valve
979-15 / 679-15
Modulating Float Control Valve with Solenoid (On-Off) Feature
979-20 / 679-20
Modulating Float Control Valve with Pressure Sustaining Feature