Ames Fire & Waterworks 910GS Stainless Steel Pressure Reducing Control Valve - Manual

01/06
910 Series Model
8550 Hansen Road • Houston, Texas 77075 • (Ph) 713.943.0688 • (Fx) 713.944.9445 • www.amesfirewater.com
Operation
The AMES Model 910 / 610 Pressure Reducing Control Valve is designed to automatically reduce a
fluctuating higher upstream pressure to a constant lower downstream pressure regardless of varying flow
rates. It is controlled by a normally open, pressure reducing pilot designed to: 1) Open (allowing fluid out of
the main valve cover chamber) when downstream pressure is below the adjustable setpoint, and 2) Close
(allowing fluid to fill the main valve cover chamber) when downstream pressure is above the adjustable
setpoint. A decrease in downstream pressure causes the valve to modulate toward an open position, raising
downstream pressure. An increase in downstream pressure causes the valve to modulate toward a closed
position, lowering downstream pressure.
Installation Guidelines
• Prior to installation, flush line to remove debris.
• Install valve horizontally “in line” (cover facing up), so flow arrow matches flow through the line. Avoid
installing valves 6” and larger vertically. Consult factory prior to ordering if installation is other than
described.
• Install inlet and outlet isolation valves. NOTE: When using butterfly valves, insure disc does not contact
control valve. Damage or improper valve seating may occur.
• Provide adequate clearance for valve servicing and maintenance.
• Install pressure gauges to monitor valve inlet and outlet pressure.
• If installation is subjected to very low flow or potentially static conditions, AMES recommends a pressure
relief valve (1/2” minimum) be installed downstream of the Pressure Reducing Valve for additional system
protection.
Other AMES Pressure Reducing Control Valves
910-01 / 610-01 Pressure Reducing Valve with Hydraulic Check Feature
910-11 / 610-11 Pressure Reducing Valve with Downstream Surge Control Feature
910-15 / 610-15 Pressure Reducing Valve with Solenoid (On-Off) Feature
910-17 / 610-17 Pressure Reducing Valve with Return Flow Feature
910-48 / 610-48 Pressure Reducing Valve with Low Flow By-Pass
912 / 612 Pressure Reducing and Pressure Sustaining Valve
912-01 / 612-01 Pressure Reducing and Sustaining Valve with Hydraulic Check Feature
910
610
PRESSURE REDUCING VALVE