Ames Fire & Waterworks 940GS-04-19 Stainless Steel Non-Surge Check Valve(6 and Larger) User Manual
940 series, Non-surge check valve, Model
01/06
940 Series
Model
8550 Hansen Road
•
Houston, Texas 77075
•
(Ph) 713.943.0688
•
(Fx) 713.944.9445
•
www.amesfirewater.com
NON-SURGE CHECK VALVE
(6” and Larger)
940-04-19
640-04-19
940-04-19 link
Operation
The AMES Model 940-04-19 / 640-04-19 Non-Surge Check Valve is designed to control pipeline surges
caused by flow reversal by slowly opening and closing at separate adjustable rates. The valve opens
when upstream pressure is greater than downstream pressure. When upstream pressure is greater than
downstream pressure, the Adjustable Opening Speed Control allows fluid out of the main valve cover
chamber, providing a controlled rate of opening. When a pressure reversal occurs and downstream pressure
becomes higher than upstream pressure, the two Adjustable Closing Speed Controls allows the higher
downstream pressure to enter the main valve cover chamber, providing a controlled rate of closure.
NOTE: A maximum pipeline velocity of six feet-per-second is recommended when installing this type of
check valve. When pipeline velocities exceed six FPS, consideration should be given to adding an AMES
Model 920 Pressure Relief Valve or Model 925 Combination Surge Anticipator and Pressure Relief Valve to
the system.
Installation Guidelines
• Prior to installation, flush line to remove debris.
• Install valve horizontally “in line” (cover facing UP), so flow arrow matches flow through the line. Avoid
installing valves 6” and larger vertically. Consult factory prior to ordering if installation is other than
described.
• Install inlet and outlet isolation valves. NOTE: When using butterfly valves, insure disc does not contact
control valve. Damage or improper valve seating may occur.
• Provide adequate clearance for valve servicing and maintenance.
• Install pressure gauges to monitor valve inlet and outlet pressure.
Other AMES Control Valves
920 / 620
Pressure Relief Valve
925 / 625
Surge Anticipator and Pressure Relief Valve
940-04 / 640-04
Non-Surge Check Valve (4” & smaller)
980-16 / 680-16
Pump Control Valve
980-16-19 / 680-16-19
Pump Control Valve with High Capacity Pilot System
985 / 685
Deep Well Pump Control Valve
985-20 / 685-20
Deep Well Pump Control Valve with Pressure Relief Feature
986 / 686
Pump Control Valve