Baumer PA220 - Manual (Page 31)

PA220
www.baumer.com 31
Activation of limit output
HIGH = enabled if displayed value ≥ limit value
LOW = enabled if displayed value ≤ limit value
Limit 2 LED SET 2 lights up
Operating mode
Time delay
Hysteresis
Time delay or hysteresis
Configuration of time delay (dLY) from 0 to 99 s or hysteresis (HYS)
from 0 to 9999 displayed units.
Activation of limit output
HIGH = enabled if displayed value ≥ limit value
LOW = enabled if displayed value ≤ limit value
An active limit output is signaled by the related LED SET 1 or 2 lit up
continuously in (dLY) mode or flashing in (HYS) mode.
4.4 Serial interface configuration
Transmission speed
1200 baud
2400 baud
4800 baud
9600 baud
19200 baud
Device address
Programmable from 01 to 99
Communication protocol
Protocol ASCII
Protocol ISO 1745
Protocol MODBUS (RTU)
Response reaction time
No delay
Delay 30 ms
Delay 60 ms
Delay 100 ms
Delay 300 ms