Baumer PA220 - Manual (Page 28)

PA220
28 www.baumer.com
Programming
1. Press to access programming mode. [Pro] appears in the
display, LED PROG starts flashing.
2. Press to select the required programming module. Each modu-
le comes with its individual abbreviation (InP, dSP, Set, S.out).
3. Proceed with line parameterization using keys , and .
4. Where required, proceed alike for parameterization in the remai-
ning modules. Once [Pro] has appeared in the display again, press
to exit programming mode. [Stor] appears briefly to indicate
parameter saving.
5. Programming mode also provides optional programming lock (see
chapter „Programming lock by authorization code“). In this case,
each programming line is visible but secured by parameter lock
which will be signaled by [DAtA] appearing in the display instead
of [Pro].
Overview on configuration module
Access/exit
programming mode
Configuration
input signal
Configuration
of the serial interface
Configuration
of limit outputs
Configuration
of the display
Module S.out is only available if the device provides the optional
„serial interface“.
4.1 Input configuration
Select input configuration
Voltage ±10 V
Voltage shunt ±100 mV
Current ±20 mA
Voltage ±60 V
4.2 Display configuration
First step in the module: Select with key one of the 4 sub-mo-
dules (SCAL, tEAc, Fil, bri).
For sub-module configuration proceed as described further down be-
low.