Baumer BA DenexMicro - Manual (Page 8)

User Manual DENEX MICRO 8/24 Baumer Electric AG
Version 2013-02, V1.6 www.baumer.com Frauenfeld, Switzerland
4.4 Mounting with a hole for the laser
If there are mechanical parts 200-300 mm under the sensor that can cause reflections to
the detectors, the following mounting is recommended. It requires a small hole on the
conveyor, or a plate with a hole to screen off the reflection from the parts. The beam must
still be stopped with a dark plate or other material if there is any risk for a person to look
into the laser. Make sure that the laser goes through the hole properly. Normal back-edges
are not counted with this mounting.
Figure 4.4.1 Mounting with a hole to let the laser through.
100