beautypg.com

Operating your vehicle, Engine break-in recommendations, Turn signal/wiper/washer/high beam lever – Dodge 2013 Dart - User Guide User Manual

Page 26: Turn signal/lane change assist

background image

ENGINE BREAK-IN RECOMMENDATIONS

• A long break-in period is not required for the engine and drivetrain (transmission and

axle) in your vehicle.

• Drive moderately during the first 300 miles (500 km). After the initial 60 miles (100 km),

speeds up to 50 or 55 mph (80 or 90 km/h) are desirable.

• While cruising, brief full-throttle acceleration within the limits of local traffic laws

contributes to a good break-in. Wide-open throttle acceleration in low gear can be
detrimental and should be avoided.

• The engine oil installed in the engine at the factory is a high-quality energy conserving

type lubricant. Oil changes should be consistent with anticipated climate conditions
under which vehicle operations will occur. For the recommended viscosity and quality
grades, refer to “Maintaining Your Vehicle”.

NOTE:
A new engine may consume some oil during its first few thousand miles (kilometers) of
operation. This should be considered a normal part of the break-in and not interpreted as
an indication to an engine problem or malfunction.

CAUTION!

Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage may result.

TURN SIGNAL/WIPER/WASHER/HIGH BEAM LEVER

Turn Signal/Lane Change Assist

• Tap the lever up or down once and the turn signal (right or left) will flash three times and

automatically turn off.

OPERATING YOUR VEHICLE

24