beautypg.com

Engine starting/stopping, Accessory positions with engine off, Getting started – Dodge 2013 Dart - User Guide User Manual

Page 14

background image

Engine Starting/Stopping

Starting

• With a valid Keyless Enter-N-Go™ Key Fob

inside the vehicle.

• Place the shift lever in PARK or NEUTRAL.

• While pressing the brake pedal, press the

ENGINE START/STOP button once. If the
engine fails to start, the starter will disen-
gage automatically after 10 seconds.

• To stop the cranking of the engine prior to

the engine starting, press the button
again.

NOTE:
In case the ignition switch does not change
with the push of a button, the RKE transmit-
ter (Key Fob) may have a low or dead battery.
In this situation a back up method can be
used to operate the ignition switch. Put the nose side of the Key Fob against the ENGINE
START/STOP button and push to operate the ignition switch.

Stopping

• Bring the vehicle to a complete stop.

• Place the shift lever in the PARK position.

• Press the ENGINE START/STOP button once. The ignition switch will return to the OFF

position.

NOTE:
If the shift lever is not in PARK and the vehicle is in motion, the ENGINE START/STOP
button must be held for two seconds with the vehicle speed above 5 mph (8 km/h) before
the engine will shut off.

Accessory Positions with Engine Off

NOTE:
The following functions are with the driver’s foot OFF the Brake Pedal (Transmission in PARK
or NEUTRAL Position).

Starting With The Ignition Switch In The OFF Position:

• Press the ENGINE START/STOP button once to change the ignition switch to the ACC

position.

• Press the ENGINE START/STOP button a second time to change the ignition switch to the

ON/RUN position.

1 — Engine Start/Stop Button

GETTING STARTED

12