NISSAN 2012 LEAF - Navigation System Owner's Manual - Manual (Page 142)

4-12 Audio system
*
4 [Direct]:
Input the channel number by using a keypad.
*
5 [Info]:
Indicates the broadcasting station information
currently being received.
*
6 [SCAN]:
Touch to tune from low to high frequencies and
stop at each broadcasting channel for 5 seconds.
*
7 Displays the preset channel list. If 1 of the 6
preset stations listed is touched and held, the
current station will be stored as the new preset.
Selecting channel/category
TUNE (Tuning):
For AM and FM radio:
Push the TUNE SEEK CH button for manual
tuning.
For XM satellite radio:
Push the TUNE SEEK CH button to seek
channels from all of the categories.
During satellite radio reception, the following
messages will be displayed under certain
conditions.
. No Signal (No signal is received while the
SAT tuner is connected)
. Channel Off Air (Broadcasting signed off)
. Check Antenna (Antenna connection error)
. Loading (The system is receiving the music
or information that is provided from the
selected channel)
. Channel Not Available (No channels are
searched)
. Channel Not Authorized (There is no user
subscription to this channel)
SEEK tuning:
For AM and FM radio:
Push the TUNE SEEK CH button for less than
1.5 seconds to tune from low to high or high to
low frequencies and to stop at the next broad-
casting station.
When the TUNE SEEK CH button is pushed
and held, radio frequencies will increase or
decrease by skipping the broadcasting stations.
When the button is released, the next broad-
casting station is selected.
SCAN tuning:
Touch [SCAN] to tune from low to high
frequencies and stop at each broadcasting
station/channel for 5 seconds.
Touch [SCAN] again during this 5 second
period to stop SCAN tuning. The radio will
remain tuned to that station/channel.
If [SCAN] is not touched within 5 seconds,
SCAN tuning moves to the next station/channel.
Storing stations/channels
12 stations/channels can be set for the FM band
(6 each for FM1 and FM2), 18 for XM radio (6
each for XM1, XM2 and XM3) and 6 stations
can be set for the AM band.
1. Choose the radio band pushing the FM·AM
button or XM button.
2. Tune to the preferred station/channel push-
ing the TUNE SEEK CH button.
3. Touch and hold one of the preset lists to
register the chosen broadcasting station or
channel.
COMPACT DISC (CD) PLAYER OP-
ERATION