beautypg.com

Locks – FORD 2013 Fusion Hybrid v.1 User Manual

Page 59

background image

All personal codes are now erased and only
the factory set 5–digit code will work.

Anti-Scan Feature

The keypad will go into an anti-scan mode
if the wrong code has been entered seven
times (35 consecutive button presses).
This mode disables the keypad for one
minute and the keypad lamp will flash.

The anti-scan feature will turn off after:

one minute of keypad inactivity

pressing the unlock button on the
remote control

the ignition is switched on

unlocking the vehicle using intelligent
access (if equipped).

Unlocking and Locking the Doors

To Unlock the Driver’s Door

Enter the factory set 5-digit code or your
personal code. Each number must be
pressed within five seconds of each other.
The interior lamps will illuminate.

Note: All doors will unlock if the all door
unlocking mode is enabled. See Locking
and Unlocking
(page 52).

To Unlock All Doors

Enter the factory set code or your personal
code, then press 3·4 within five seconds.

To Lock All Doors

Press and hold 7·8 and 9·0 at the same
time (with the driver’s door closed). You
do not need to enter the keypad code first.

To Release the Trunk

Enter the factory set code or your personal
code, then press 5·6 within five seconds.

Displaying the Factory Set Code

With Integrated Keyhead Transmitters

Note: You will need to have two
programmed passive anti-theft keys for this
procedure.

To display the factory set code in the
information display:

1.

Insert a key into the ignition and turn
the ignition on for a few seconds.

2. Turn the ignition off and remove the

key.

3. Insert the second key into the ignition

and turn the ignition on.

The factory set code will display for a few
seconds.

Note: The code may not display until after
any other warning messages first display.

With Intelligent Access Keys

Note: You will need to have two
programmed intelligent access keys for this
procedure.

To display the factory set code in the
information display:

1.

Place the first programmed key in the
backup slot inside the center console.

2. Press the START/STOP button once

and wait a few seconds.

3. Press the START/STOP button again

and remove the key.

4. Insert the second programmed key into

the backup slot, then press the
START/STOP button.

The factory set code will appear in the
information display for a few seconds.

Note: The code may not display until after
any other warning messages first display.

57

Locks