Locks – FORD 2013 Fusion Hybrid v.1 User Manual
Page 58
1 2
3 4
5 6
7 8
9 0
E138637
You can use the keypad to:
•
lock or unlock the doors
•
release the trunk
•
recall memory seat and mirror
positions (if equipped)
•
program and erase user codes
•
arm and disarm the anti-theft alarm.
The keypad can be operated with the
factory set 5-digit entry code. The code is
located on the owner’s wallet card in the
glove box and is available from your
authorized dealer. You can also create up
to five of your own 5-digit personal entry
codes.
Programming a Personal Entry Code
To create your own personal entry code:
1.
Enter the factory set code.
2. Press 1·2 on the keypad within five
seconds.
3. Enter your personal 5-digit code. Each
number must be entered within five
seconds of each other.
4. Press 1·2 on the keypad to save
personal code 1.
The doors will lock then unlock to confirm
that your personal entry code has been
programmed.
To program additional personal entry
codes, repeat Steps 1-3, then for Step 4:
•
press 3·4 to save personal code 2
•
press 5·6 to save personal code 3
•
press 7·8 to save personal code 4
•
press 9·0 to save personal code 5.
You may also program a personal entry
code through the MyFord Touch system
(if equipped). See Settings (page 357).
Tips:
•
Do not set a code that uses five of the
same number.
•
Do not use five numbers in sequential
order.
•
The factory set code will work even if
you have set your own personal code.
Recalling Memory Positions (If
Equipped)
The programmed entry codes will recall
driver memory positions as follows:
•
Entry code 1 will recall driver 1 memory
positions.
•
Entry code 2 will recall driver 2 memory
positions.
•
Entry code 3 will recall driver 3 memory
positions.
Note: Personal entry codes 4 and 5 will not
recall memory positions.
Erasing a Personal Code
1.
Enter the factory set 5-digit code.
2. Press and release 1·2 on the keypad
within five seconds.
3. Press and hold 1·2 for two seconds.
This must be done within five seconds
of completing Step 2.
56
Locks