Starting and stopping the engine – FORD 2013 Fusion Hybrid v.1 User Manual
Page 148
Note: A valid key must be located inside
your vehicle to switch the ignition on and
start the engine.
Switching the Ignition On
(Accessory Mode)
E144447
Press the START button once. It is located
on the instrument panel near the steering
wheel. All electrical circuits and
accessories are operational and the
warning lamps and indicators illuminate.
Starting Your Vehicle
Carry out the following steps to start your
vehicle:
1.
Fully press the brake pedal.
2. Move the transmission selector lever
to position P.
3. Press the START button.
The system does not function if:
•
The key frequencies are jammed.
•
The key battery has no charge.
If you are unable to start your vehicle, do
the following:
E147165
1.
Place the remote in the backup slot
inside the center console.
2. With the key in this position, press the
brake pedal, then the START button to
switch the ignition on and start your
vehicle.
Stopping the Engine When Your
Vehicle is Stationary
1.
Move the transmission selector lever
to position P.
2. Press the START button once.
Note: The ignition, all electrical circuits
warning lamps and indicators will be
switched off.
Note: If the engine is left unattended for 30
minutes, the ignition and engine
automatically shut down.
Stopping the Engine When Your
Vehicle is Moving
1.
Press and hold the START button for
one second, or press it three times
within two seconds.
2. Move the transmission selector lever
to position N and use the brakes to
bring your vehicle to a safe stop.
3. When your vehicle has stopped, move
the transmission selector lever to
position P and switch the ignition off.
146
Starting and Stopping the Engine