FORD 2013 Explorer v.1 - Manual (Page 196)

Reprogramming a single button
To program a device to a previously trained button, follow these steps:
1. Press and hold the desired button. Do NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the button, follow Step 1 in the Programming section.
For questions or comments, contact HomeLink
௡ at www.homelink.com or
1-800-355-3515.
Programming HomeLink ா to a Genie Intellicodeா 2 garage door
opener
Note: The Genie Intellicode 2
௡ transmitter must already be programmed
to operate with the garage door opener.
Programing the transmitters
To program HomeLink
௡ to the transmitter you must first put the
transmitter into programming mode. To do this
A. Red LED
B. Green LED
1. Press and hold one of the buttons on the transmitter for 10 seconds.
The LED light will change from green to green and red.
2. Press the same button twice to confirm the change to Programming
mode. If done properly the LED light will appear red.
3. Hold the transmitter within 1–3 inches (2–8 cm) of the HomeLink
௡
button.
4. Press and hold the both the programmed Genie button and the
HomeLink
௡ button you want to program. The HomeLink௡ LED will flash
rapidly when the programming is successful.
B A
196 Universal Garage Door Opener
2013 Explorer (exp)
Owners Guide gf, 1st Printing
USA (fus)