Edge Lighting Twin Slim LED - Dimmable - Manual

Installation Instructions for Twin Slim LED
904-TWINSLIM-20-LED-02
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
Install the Mounting Plate
1
TWINSLIM-20-LED
© 2014 Edge Lighting. All Rights Reserved.
A
1: Loosen and remove the four M6 screws on the top and
bottom of the mounting plate with the 3mm Allen wrench.
2: Pull the mounting plate completely out of the mirror.
SAVE THESE INSTRUCTIONS!
- This product is wall mounted only.
- Supply power to mirror in accordance with local electrical
codes.
- This instruction shows a typical installation
- This product is dimmable with ELV dimmers.
IMPORTANT INFORMATION
NOTE: It is recommended that one person holds the mounting
plate while the electrician installs it.
B
3: Align the mounting plate hole with the power line conduit, or
junction box. Use the mounting plate as a template to
mark eight mounting holes (highlighted in GREEN) onto the
wall.
NOTE: Make sure that the mounting plate is leveled horizontally.
M6 SCREW
MIRROR
MOUNTING
PLATE
1
2
ALIGN
CENTER
WITH
JUNCTION
BOX
MOUNTING
HOLE
3
3
MOUNTING
PLATE
MIRROR
4: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
5: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
ANCHOR
ANCHOR MUST
BE FLUSH TO WALL
H
WALL
4
5