Edge Lighting Twin Slim Dimmable - Manual

SAVE THESE INSTRUCTIONS!
- This product is for wall mounted Mirror installations only.
- This product is to be used only with Edge Lighting Mirrors.
Installation Instructions for
Mirror Defogger
904-DF-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
Install the Defogger to a Mirror
1
A
DF-R_
© 2012 Edge Lighting. All Rights Reserved.
1: Refer to instructions provided with the mirror assembly to
remove the mirror.
NOTE: Below are the steps on how to install defogger to an
Edge lighting mirror, for additional information refer to the
instruction provided with the mirror.
G N L
G N L
MIRROR MOUNTING PLATE
1
B
BACK OF
THE MIRROR
2
2: Gently place the mirror on a padded flat surface, and clean
the back of the mirror from any dust or grease. Make sure to
completely dry mirror before continuing.
C 3: Remove the backing from the defogger and firmly press it
down on back of the dimmer, little at a time to avoid air
bubbles.
4: Connect the defogger wires to the 120 Volt power wires with
wire nuts.
MIRROR
DEFOGGER
BACKING
3
WIRES