Edge Lighting Plaza Large Dimmable - Manual

G N L
G N L
G N L
G N L
Installation Instructions for Plaza Large
904-PLAZA-L-F1D-05
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
Install the Mounting Plate
1
PLAZA-L-F1-_
© 2012 Edge Lighting. All Rights Reserved.
A
1: Loosen and remove the four M6 screws on the top and
bottom of the mounting plate with the 3mm Allen wrench.
2: Pull the mounting plate completely out of the mirror.
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This product is wall mounted only.
- Supply power to mirror in accordance with local electrical
codes.
- This instruction shows a typical installation
- This product is dimmable with 0-10V dimmers.
IMPORTANT INFORMATION
NOTE: It is recommended that one person holds the mounting
plate while the electrician installs it.
B
M6 SCREW
3MM ALLEN
WRENCH
MIRROR MOUNTING PLATE
1 1
1 1
2
3
PLAZA-L-F1D-_
MOUNTING PLATE
CENTER HOLE
3
3: Align the mounting plate hole with the power line conduit, or
electrical box, and use the mounting plate as a template to
mark four mounting holes onto the wall.
NOTE: Make sure that the mounting plate is leveled
horizontally.
4: Use a 9/32 drill bit to make holes on all six marked points.
5: Tap the anchors into the drilled holes with a hammer.
C
WALL
4
ANCHOR
9/32
DRILL BIT
5 5