Edge Lighting Plaza Small Dimmable - Manual

SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This product is wall mounted only.
- Supply power to mirror in accordance with local electrical
codes.
- This instruction shows a typical installation
- This product is dimmable with 0-10V dimmers.
Installation Instructions for
Plaza Small Dimmable
904-PLAZA-S-F1D-01
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: 773-770-1195
Fax: 773-935-5613
www.edgelighting.com
[email protected]
Install the Fixture
A
PLAZA-S-F1D-_
ELECTRICAL BOX
© 2012 Edge Lighting. All Rights Reserved.
1: Feed the power wires through the crossbar assembly center
hole.
2: Mount the crossbar assembly to the electrical box holes with
the provided #8-32 screws.
CROSSBAR ASSEMBLY
POWER WIRE
#8-32 SCREW
1
2 2
B
3: Align the mounting plate center hole with the crossbar
assembly nipple and slide onto the nipple.
4: Level the mounting plate horizontally and mark the six
mounting plate holes onto the wall. These points are for the
anchors.
5: Remove the mounting plate.
CROSSBAR ASSEMBLY MOUNTING PLATE
1
G N L
G N L
4
4
4
4
4
3
4