Install the lamp & mirror, Max 24 – Edge Lighting Twin Slim Dimmable User Manual

Page 2

POWER LINE

CONNECTOR

Install the Lamp & Mirror

LAMP

SOCKET

MOUNTING PLATE

#8 SCREW

MIRROR
HOUSING

Use

MAX 24

Watt Type T5 HO,

Linear Fluorescent Lamp For Each Socket.

1: Line up the lamp pins on both sides with the opening on the
socket.

2: Insert the lamp pins all the way into the sockets and turn the
lamp to lock it in place. Repeat this step for the other lamp.

3: Place the mirror housing onto the mounting plate and secure
it in place by tightening the four #8 screw on the top
and bottom of the mirror housing into the mounting plate.

CAUTION:

To reduce risk of a burn or electrical shock during

lamping, disconnect the power to the fixture.

VIOLET

GRAY

(+) Dimming

(-) Control

GREEN

WHITE

BLACK

BALLAST

TAB

WAGO
CONNECTOR

4: Install the conduit connector (not provided) to mounting
plate hole. Feed the power line through the conduit
connector into the mounting plate.

5: Line up the mounting plate holes with the anchors and
secure it to the anchors with the six #8-32 screws provided.

6: Make sure that the mounting plate is grounded in
accordance with local electrical codes.

7: Connect the hot, neutral & ground power wires into the
wago connector.

NOTE:

If necessary, push the tab down and then pull the Wago

connector for a quick disconnect.

NOTE:

Omit steps 8 & 9 for non-dimming wiring.

8: For dimming, run the violet and gray wires from the dimmer
to the ballast. The wires must be solid copper (refer to the
dimmer instruction for more details).

9: Insert the violet wire to the (+) & the gray wire (-) ballast
terminal respectively.

#8-32
SCREW

NOTE:

NEMA fluorescent lamp manufacturers recommend to

reduce possible flicker or instability when new dimming systems
are comissioned, lamps should be operated at the ballast's
maximum light output setting overnight (approximately
12 hours).