beautypg.com

Customizing features / options, Models ep34 & ep40) – EcoPure EP40 User Manual

Page 17

background image

17

ADJUSTABLE BACKWASH

If your incoming water supply has higher sediments

or clear water iron, a longer Backwash and/or Fast

Rinse time may help in keeping the unit cleaner.
To change the length of the Backwash:
1. Press and hold the SELECT button until the screen

in Figure 38 is displayed.

2. Press the SELECT button twice, so that “SET TIME

bA” appears in the display (See Figure 39).

3. Press the

p

UP or

q

DOWN buttons to set the

length of Backwash in minutes.*

4. When the desired Backwash time appears in the

display, press the SELECT button twice to return to

the normal run (time of day) screen.

ADJUSTABLE FAST RINSE

To change the length of the Fast Rinse:
1. Press and hold the SELECT button until the screen

in Figure 38 is displayed.

2. Press the SELECT button three times, so that

“SET TIME Fr” appears in the display (See Figure

40).

3. Press the

p

UP or

q

DOWN buttons to set the

length of Fast Rinse in minutes.*

4. When the desired Fast Rinse time appears in the

display, press the SELECT button once to return to

the normal run (time of day) screen.

* Setting backwash and/or fast rinse times too low

may result in salty tasting water after regeneration.

RECHARGE NOW

At times of greater than normal water use, such as

when you have guests, you could run out of condi-

tioned water before the next scheduled recharge. If

this happens, you may want to initiate an immediate

regeneration, as follows:
1. Press and hold the RECHARGE button until the

words “RECHARGE NOW" flash in the display.

The softener enters the fill cycle of regeneration right

away. “RECHARGE NOW” will flash during the

regeneration. When completed (in about 2 hours),

full water conditioning capacity is restored.
NOTE: Avoid using hot water while the softener is

regenerating, because the water heater will

refill with bypass hard water.

RECHARGE TONIGHT

If you do not want to start an immediate recharge, but

would like an extra recharge at the next preset

recharge time, do the following to schedule a

recharge:
1. Press and release (do not hold) the RECHARGE

button.

The words “RECHARGE TONIGHT" flash in the dis-

play, and the softener will recharge at the next preset

recharge time (If you decide to cancel the regenera-

tion before it begins, press and release the

RECHARGE button once more, and “RECHARGE

TONIGHT” will disappear from the display). During

regeneration, the word “RECHARGE NOW" will flash

in the screen. When completed, full water condition-

ing capacity is restored.

RECHARGE NOW initiated

FIG. 36

RECHARGE TONIGHT initiated

FIG. 37

FIG. 38

FIG. 39

FIG. 40

Customizing Features / Options

(Models EP34 & EP40)

This manual is related to the following products: