EcoPure EP40 - Manual (Page 13)

13
SET RECHARGE (REGENERATION) TIME
Your demand water softener will automatically regen-
erate when it needs to, based on water usage. The
time of day that the automatic recharge cycle begins
may be changed as follows:
1. Press the SELECT button once again to display a
flashing “2:00AM” and the words “RECHARGE
TIME”. This is a good time for the recharge to start
in most households, because water is not in use.
2. If you want to change the recharge start time,
press the p UP or q DOWN buttons until the
desired time shows. Be sure AM or PM is correct.
3. Press the SELECT button once more to complete
the initial programming. The current time of day
will show in the display.
FIG. 19
FIG. 20
Questions? Call Toll Free 1-800-693-1138 Monday- Friday, 7 AM - 6 PM CST
or visit www.ecopurewaterproducts.com
When you call, please be prepared to provide the model and serial number,
found on the rating decal, located on the rim below the salt lid hinges.
2. Press the p UP or q DOWN buttons to set ON or
OFF. When set to ON, the efficiency icon will be
displayed in the upper right hand corner of the nor-
mal run display.
FIG. 22
FIG. 21 Efficiency Icon
3. Press the SELECT button three times, to return to
the normal run display (See Figure 22).
Displayed when efficiency
is set to “ON”
SET SALT EFFICIENCY
When this feature is ON, the water softener will oper-
ate at salt efficiencies of 4000 grains of hardness per
pound of salt or higher (May recharge more often
using smaller salt dosage but more regeneration
water). The softener is shipped with this feature set
OFF.
1. Press and hold the SELECT button until one of the
screens in Figure 20 is displayed. Once in this dis-
play, press the SELECT button once and one of
the two displays in Figure 21 is shown.
Programming the Water Softener
(Models EP27 & EP30)