Programming the water softener, Models ep34 & ep40) – EcoPure EP40 User Manual

Page 16

FIG. 31

SET RECHARGE (REGENERATION) TIME

Your demand water softener will automatically regen-

erate when it needs to, based on water usage. The

time of day that the automatic recharge cycle begins

may be changed as follows:
1. Press the SELECT button once again to display a

flashing “2:00AM” and the words “SET RECHARGE

TIME”. This is a good time for the recharge to start

in most households, because water is not in use.

2. If you want to change the recharge start time,

press the

UP or

DOWN buttons until the

desired time shows. Be sure AM or PM is correct.

SET SALT LEVEL

The water softener has a low salt indicator light to

remind you to refill the storage tank with salt.
NOTE: You must set salt level each time salt is added

to the water softener.

To set this monitor system:
1. Lift the salt lid and level the salt in the storage tank.
2. The yellow salt level decal, on the brinewell inside

the tank, has numbers from 0 to 8. Observe the

highest number the leveled salt is at, or closest to.

3. Press the SELECT button to display a flashing

“OFF” and the words “SET SALT LEVEL”.

4. Press the

UP button until the number on the

screen corresponds to the salt level. At level 2 or

below, the “Low Salt" LED indicator will flash. If

you wish to turn this feature off, press the

DOWN button past 0, and the word “OFF” flash-

es in the display.

5. Press the SELECT button once more to complete

the initial programming. The current time of day

will show in the display.

FIG. 32

SET SALT EFFICIENCY

When this feature is ON, the water softener will oper-

ate at salt efficiencies of 4000 grains of hardness per

pound of salt or higher (May recharge more often

using smaller salt dosage but more regeneration

water). The softener is shipped with this feature set

OFF.
1. Press and hold the SELECT button until one of the

screens in Figure 33 is displayed. Once in this dis-

play, press the SELECT button once and one of

the two displays in Figure 34 is shown.

2. Press the

UP or

DOWN buttons to set ON or

OFF. When set to ON, the efficiency icon will be

displayed on the right hand side of the normal run

display.

3. Press the SELECT button three times, to return to

the normal run display (See Figure 35).

FIG. 33

FIG. 34

Efficiency Icon

FIG. 35

Displayed when efficiency

is set to “ON”

Programming the Water Softener

(Models EP34 & EP40)

This manual is related to the following products:

EP34