Dick SM-140 UltraSharp 230V - Manual (Page 17)

Belt grinder SM-140 17
Putting into operation
7
The belt grinder is installed on the machine bases [1] on
a slipproof, clean and flat surface.
7.3 Setting & adjusting the belt grinder
Adjusting the deflector plate
CAUTION
Risk of injuries due to rotating machine parts
• Remove the plug from the socket before carrying out any
adjustment work.
CAUTION
Risk of injuries due to rotating machine parts
• The distance between the deflection plate and polishing
wheel must be checked each time before starting work
using the belt grinder, and if necessary readjusted.
Figure 7.2 – Adjusting the deflection plate
[1] Deflection plate
[2] Distance (2 mm maximum)
[3] Polishing wheel
[4] Knurled nut
1
2
3
4