Signal alarm enable, Tx rate alarm below, Tx rate alarm enable – Baseline Systems FreeWave Ethernet Radio User Manual
Page 99: Vswr alarm above
User Manual and Reference Guide
LUM0024AB Rev A
Signal Alarm Enable
Web Parameter:
Signal Enable check box in the SNMP Trap Limits section of the SNMP
page.
Network Type:
Both
Default Setting:
Disabled
Options:
Disabled, Enabled
Description:
Enables a trap for the Signal Level the transceiver reports. The trap condition
is present based on the settings in the Signal Alarm Below parameter.
Tx Rate Alarm Below
Web Parameter:
Tx % Rate Below in the SNMP Trap Limits section of the SNMP page.
Network Type:
Both
Default Setting:
50
Options:
Any percentage between 50 and 100, in increments of 5.
Description:
If the Tx Rate Alarm Enabled option is set to Enabled, a trap condition
occurs if the transmit percent goes below the value in this parameter.
Tx Rate Alarm Enable
Web Parameter:
Tx % Rate Enable check box in the SNMP Trap Limits section of the SNMP
page.
Network Type:
Both
Default Setting:
Disabled
Options:
Disabled, Enabled
Description:
Enables a trap for the transmit percentage of the transceiver. The trap
condition is present based on the settings in the Tx Rate Alarm Below
parameter.
VSWR Alarm Above
Web Parameter:
Reflected Power Above in the SNMP Trap Limits section of the SNMP page.
Network Type:
Both
Default Setting:
2
Options:
Any whole J-Units between 0 and 40, in increments of 2.
Description:
If the VSWR Alarm Enabled option is set to Enabled, a trap condition occurs
if the reflected power goes above the value in this parameter.
83