Noise alarm enable, Rx rate alarm below, Rx rate alarm enable – Baseline Systems FreeWave Ethernet Radio User Manual
Page 98: Signal alarm below
FGR2-PE Wirelss Data Transceiver
LUM0024AB Rev A
Options:
Any whole, negative number between -100 and -70 db, in increments of 5.
Description:
If the Noise Alarm Enable option is set to Enabled, a trap condition occurs if
the Noise Level goes above the value in this parameter.
Noise Alarm Enable
Web Parameter:
Noise Enable check box in the SNMP Trap Limits section of the SNMP page.
Network Type:
Both
Default Setting:
Disabled
Options:
Disabled, Enabled
Description:
Enables a trap for the Noise Level of the transceiver. The trap condition is
present based on the settings in the Noise Alarm Above parameter.
Rx Rate Alarm Below
Web Parameter:
Rx % Rate Below in the SNMP Trap Limits section of the SNMP page.
Network Type:
Both
Default Setting:
50
Options:
Any percentage between 50 and 100, in increments of 5.
Description:
If the Rx Rate Alarm Enabled option is set to Enabled, a trap condition
occurs if the receive percent goes below the value in this parameter.
Rx Rate Alarm Enable
Web Parameter:
Rx % Rate Enable check box in the SNMP Trap Limits section of the SNMP
page.
Network Type:
Both
Default Setting:
Disabled
Options:
Disabled, Enabled
Description:
Enables a trap for the receive percentage of the transceiver. The trap condition
is present based on the settings in the Rx Rate Alarm Below parameter.
Signal Alarm Below
Web Parameter:
Signal Alarm Below in the SNMP Trap Limits section of the SNMP page.
Network Type:
Both
Default Setting:
-90
Options:
Any whole, negative number between -100 and -70 db, in increments of 5.
Description:
If the Signal Alarm Enable option is set to Enabled, a trap condition occurs
if the signal level goes below the value in this parameter.
82