B&G Network Quad - Manual (Page 26)

USING THE TIMER/TEMP KEY
Press the TIMER/TEMP key to cycle through the options:
TRIP LOG A reset log that can be displayed in Nautical
miles or Statute Miles. This is determined by the
selection of the displayed speed units (see
SETTING THE SPEED AND LOG UNITS). It
also resets the Maximum and Average Speed
values.
LOG The Stored Log, in NM or M as above.
TIMER There are three timers available:
1. 10 minute count-down
2. 5 minute count-down
3. Count-up starting from zero.
• The 10 minute count-down timer sounds a bleep at 5
and 1 minute, and then at 30, 20, 10, 5, 4, 3, 2, 1
seconds.
• The 5 minute count-down timer sounds a bleep at 1
minute, and then at 30, 20, 10, 5, 4, 3, 2, 1 seconds.
• All the timers count in one second intervals up to 99
hours, 59 minutes and 59 seconds.
• When a count-down timer reaches zero it will begin to
count up.
• All timers have a Lap Time facility that will freeze the
displayed time while the timer remains counting.
SEA TEMPERATURE
The Sea Temperature is displayed in °C Celsius or °F
Fahrenheit.
610-HB-0503-05 26