B&G Network Pilot - Manual (Page 3)

3
INTRODUCTION TO NETWORK PILOT
This manual describes how to operate your Network PILOT
after it has been installed, commissioned and had it's initial
sea trial. These procedures are all described in the Network
PILOT Installation Manual.
Network PILOT can be used as a stand-alone autopilot with
a Network PILOT Display Unit and/or a Hand-held Controller
or as part of an integrated Network navigational system,
used in conjunction with any of the units listed above.
SWITCHING THE PILOT ON
Your Network PILOT will usually have two circuit breakers,
one which supplies the Network PILOT Display and Network
Instruments (light duty supply) and the other that supplies the
Ram Drive or Pump Unit (heavy duty supply). Both must be
switched on before the autopilot will operate.