B&G Network Compass - Manual (Page 19)

NETWORK COMPASS USER MANUAL
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
Display fails to light up
Power not connected.
Supply not 10 to 16 Volts.
Data is not repeated from Network
Compass not in repeater mode.
Cables not correctly fitted.
Compass fails to calibrate (-F-)
Calibration manoeuvre performed badly.
Compass installed too close to onboard
metallic object.
Calibration manoeuvre attempted near to
large metallic vessel or equipment, e.g.
loading crane.
Display shows a number and the
Error message. Switch off and restart. (If
alarm buzzer sounds the message persists after three restart
attempts contact your authorised dealer
for assistance.)
-C- error message
Compass fluxgate error. Switch off check wiring.
Check that fluxgate is not too close to a metallic
object. (If the message persists after three restart
attempts contact your authorised dealer for
assistance.)
19