B&G Network Compass - Manual (Page 13)

NETWORK COMPASS USER MANUAL
SETTING THE TIMER
1. Press TIMER to enter timer mode.
2. Press SETUP to give the display h:xx (xx represents a two digit number) the h will be
flashing.
3. Press ENTER and the numbers will flash.
4. Alter the hours using the or keys. If the key is held down the numbers will change
more quickly.
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
30 20 10 30 20 10
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
5. Press ENTER to adjust the count down minutes. The display will show the current
minutes setting and the bar graph on the left will represent the minutes before time
zero (up to 30 minutes).
6. Alter the minutes using the or keys.
7. Press ENTER to set the timer, with the seconds set to zero. Both sides of the bar
graph will now be full to show that the timer is ready to be started.
8. Press ENTER to start the timer and exit to the timer display.
ENABLING/DISABLING THE TIMER BEEPS
1. Press TIMER to enter timer mode.
2. Press SETUP to give the display h:xx (xx represents a two digit number) the h will be
flashing.
3. Press SETUP to give the O:FF or :on display (colon flashing).
4. Press ENTER. The O:FF or :on will flash.
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
5. Press or keys to select :on or O:FF, enabling or disabling the beeps.
6. Press ENTER to store the new setting.
7. Press SETUP to return the unit to the timer setup display.
8. Press MODE or TIMER to return to the desired mode.
13