B&G Network Compass - Manual (Page 11)

NETWORK COMPASS USER MANUAL
THE HEAD/LIFT DISPLAY
THE HEAD/LIFT PAGE HAS TO BE ENABLED IN THE SETUP MENU before it can be
displayed.
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
HEAD
30 20 10 30 20 10
PORT
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
HEAD 30 20 10 30 20 10
STBD
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
LIFT 30 20 10 30 20 10
STBD
MODE TIMER LOCK SETUP LIGHTS
ENTER
Network COMPASS
LIFT
30 20 10 30 20 10
PORT
The port and starboard tacks are stored manually as PORT and STBD headings (see
SETTING THE COURSE MEMORIES). When the helmsman has to vary from these
headings due to wind changes the legends HEAD or LIFT will appear on the display for
the relevant tack. If wind data is available over the Network a tack will automatically
change between the PORT and STBD reference course. Otherwise it can be switched
manually by two short presses of the LOCK key or the remote button. The HEAD/LIFT
values are displayed in the analogue bar graph as degrees. If the Off Course alarm is
enabled the unit will sound an alarm and flash -A- if a head occurs. Press any key on the
unit to cancel the alarm. The alarm will not sound for a lift.
11