B&G Network Autopilot - Manual (Page 107)

6 - 7
NO NMEA NO NMEA DATA
Fault description:
XTE data from position fixer has stopped.
Check list:
1. Check XTE display on Pilot Display unit or Network NAV.
2. Check connections to Pilot system.
3. Check operation of Position Fixer, has NMEA output been selected
and enabled? Has autopilot output been enabled? Refer to Position
Fixer manual.
BAD XTE BAD NMEA DATA
Fault description:
The value of XTE data being received has suddenly changed by more
than 0.3 nautical miles.
Check list:
1. Check XTE on display for stability.
2. Check operation of Position Fixer, especially signal and noise levels.
refer to Position Fixer operation manual.
NO WIND NO WIND DATA
Fault description:
There is no valid wind data being received via the instrument system
network, or the wind speed is less than 1kt.
Check list:
1. Check Wind display on instrument system.
2. Check connections
to instrument system.