B&G Zeus2 Glass Helm ZM Display 19 - Manual (Page 15)

| 13
Operating the display | ZM Series User Manual
Option Sub option Range Description
Configuration
Power
Control Slave,
Master
In slave mode monitor will turn on if 12/24V is
detected on the yellow wire. In master mode
monitor will turn on slave devices by switching 12V
to yellow wire when monitor is on
Key Beeps Off, On Turns on or off the OSD key beeps
Factory
Reset
Yes, No Restore all settings to default
Option Sub option Description
Touch Screen
HDMI Enables serial touch control for HDMI
DVI Enables serial touch control for DVI
Enable All Enables serial touch control for HDMI and DVI
Disable Disables serial touch control
¼ Note: USB touch control is automatically enabled upon connection.
Updating the firmware
Updates to the ZM series monitor firmware may occasionally become available. The updates
will typically include improvements to existing functionality or new features, and will be
made available via the B&G website: www.bandg.com.
Checking current firmware version
On the Configuration page it is possible to see the name of the monitor, resolution (native),
OSD version, BIOS version, and the serial number.
Installing an Update
Updates should be loaded via a compatible B&G device such as the Zeus, Zeus Touch or
Zeus
2 . Refer to the applicable product manual on how to upgrade a device over NMEA 2000.
Alternatively, return the device to a Navico dealer to arrange updating.
¼ Note: we recommend updating ZM monitor software via another device on your NMEA 2000
network.
¼ Note: we do not recommend updating more than two displays at the same time. Do not
update the display being used to monitor the update status. In the rare occurrence the
update fails, nothing will be visible on the screen.