Amico Nema 4 Master Alarm - Manual (Page 14)

14 Amico Pipeline
COMPUTER INTERFACE MODULE
1. Pull the remote signal wires from the “Building management system” into the alarm panel. Make the connections
to the terminal blocks located on the side of the module. The wiring is fail-safe normally open, held closed, dry
contacts to the monitoring equipment.
2. Make the appropriate wiring connections as per wiring diagram in Appendix N.
CLOSING THE FRAME/MODULE ASSEMBLY
1. Swing up the frame assembly, ensuring that the stopper wires are folded into the back box.
2. Screw in the frame module to the top of the back box assembly by using the screws provided with the frame/module
assembly. The alarm is now ready for use!
Annunciator Module
NOISE LEVEL CONTROL
Factory Default: 90 Decibels
To decrease noise level:
1. Locate jumper at J5. Move jumper to:
LVL1 = 90 dBa.
LVL2 = 80 dBa.
LVL3 = 70 dBa.
CONTROL OF REMOTE ALARM BUZZER
Factory Default: Normal Condition
To silence remote alarm buzzer, when silencing the
annunciator module:
1. Locate jumper at J6. Move jumper to:
NORM =
Remote alarm buzzer will silence when annunciator
module is silenced.
ALRM =
Remote alarm will not silence when annunciator
module is silenced. The buzzer will only silence when
alarm condition has been cleared. Please refer to
Appendix B.
A m i c o M i c r o p r o c e s s o r B a s e d A l a r m
P a g e : 1 6
FIELD ADJUSTMENTS
THE ANNUNCIATOR MODULE
NOISE LEVEL CONTROL
Factory Default: 90 Decibles
To decrease noise level:
1. Locate jumper at J5. Move jumper to:
LVL1 = 90 dBa.
LVL2 = 80 dBa.
LVL3 = 70 dBa.
CONTROL OF REMOTE ALARM BUZZER
Factory Default: Normal Condition
To silence remote alarm buzzer when silencing the
annunciator module:
1. Locate jumper at J6. Move jumper to:
NORM =
Remote alarm buzzer will silence when annunciator
module is silenced.
ALRM =
Remote alarm will not silence when annunciator
module is silenced. The buzzer will only silence
when alarm condition has been cleared. Please
refer to Appendix B.
J
6
TEST
ALRM
NORM
SILENCE
LVL1
LVL2
LVL3
J5
A m i c o M i c r o p r o c e s s o r B a s e d A l a r m
P a g e : 1 6
FIELD ADJUSTMENTS
THE ANNUNCIATOR MODULE
NOISE LEVEL CONTROL
Factory Default: 90 Decibles
To decrease noise level:
1. Locate jumper at J5. Move jumper to:
LVL1 = 90 dBa.
LVL2 = 80 dBa.
LVL3 = 70 dBa.
CONTROL OF REMOTE ALARM BUZZER
Factory Default: Normal Condition
To silence remote alarm buzzer when silencing the
annunciator module:
1. Locate jumper at J6. Move jumper to:
NORM =
Remote alarm buzzer will silence when annunciator
module is silenced.
ALRM =
Remote alarm will not silence when annunciator
module is silenced. The buzzer will only silence
when alarm condition has been cleared. Please
refer to Appendix B.
J
6
TEST
ALRM
NORM
SILENCE
LVL1
LVL2
LVL3
J5