Great Plains 4000TM Predelivery Manual - Manual (Page 17)

Great Plains Manufacturing, Inc. Assembly 13
03/19/2014 586-537Q
Outside Wing & Brace Bar
Refer to Figure 12
48. Attach wing brace
to front of wing frame with 3/4 x 2
Gr. 5 hex bolts , 3/4 lock washers and 3/4 nuts.
49. Remove wing hinge pins from center frame hinge .
Attach wing frame assemblies to center frame with
the wing hinge pins , 1 1/4 flat washers (rear side of
wing hinge tubes only, do not use on wing brace bar) and
1 top lock nuts.
50. Do not hook up rod end of fold cylinder until system is
purged of air. See “Purging Hydraulic System” on
page 23.
51. Bolt may be tightened to specs, See “Torque Values
Chart” on page 35.
Figure 12
Outside Wing & Brace Bar
42390
3
2
1
7
U
D
F
B
L
R
4
5
6 6
1
2
4 5
3 5
4 6
7