Great Plains 4000TM Predelivery Manual - Manual (Page 12)

586-537Q 03/19/2014
8 3500-4000TM Great Plains Manufacturing, Inc.
Assembly
Center Brace Bar
Refer to Figure 5
Note: The center brace bar, front trusses, level bar and hitch
may need to be installed on truck so machine may be
pulled off side of truck. The bolt kit needed for assem-
bling these items will be shipped in a bag tied to front of
center frame. The center will be shipped partially pre-
assembled. See “Parts Manual” for part numbers and
description of parts.
17. Align holes in plates of the center brace bar with
holes on front of center frame , secure with 3/4 x 2 hex
bolts , 3/4 lock washers and 3/4 nuts.
18. Both outside plates (bottom holes only, 4 total) will
require 3/4 x 7 hex bolts , 3/4 lock washers and 3/4
nuts.
19. Bolts may be tightened to specs, See “Torque Values
Chart” on page 35.
Valve Brackets & Valves
Refer to Figure 6
Note: Bolts needed in these next steps will be bolted on parts
or located in a bag on front of center frame.
20. Remove the 1/2 x 3 1/32 x 6 u-bolts from the valve
brackets and , Attach bypass and counterbalance
valve bracket and lock valve bracket to center brace
bar in proper locations, shown, See “Valve Brackets
& Hoses” on page 9, with the same 1/2 x 3 1/32 x 6 u-
bolts
, 1/2 lock washers and 1/2 nuts.
21. Be sure hoses are routed as shown in, See “Valve
Brackets & Hoses” on page 9.
22. Install bypass valve on top of valve bracket with 5/
16 x 3 Gr. 5 hex bolts , 5/16 lock washers and 5/16
nuts.
23. Fasten the counter balance valve to side of valve
bracket with 5/16 x 4 Gr. 5 hex bolts , 5/16 lock
washers and 5/16 nuts.
24. Install the lock valve to the top of the valve bracket
with 1/4 x 2 Gr. 5 hex bolts , 1/4 lock washers and 1/4
nuts.
Note: Bolts may be tightened to specs, See “Torque Values
Chart” on page 35
Figure 5
Center Brace Bar
42866
2
4
3
U
D
F
B
L
R
3
4
3
1
1
2
3
4
2
1
5
U
D
F
B
L
R
7
4
6
Figure 6
Valve Brackets & Valves
42868
8
9
13
14
3
10
4
1 2
1 2
3
4
5 1
6
7
1 8
9 2
10