Great Plains 4000TM Predelivery Manual - Manual (Page 16)

12 3500-4000TM Great Plains Manufacturing, Inc.
586-537Q 03/19/2014
Inside Wing, Brace Bar & Fold
Refer to Figure 11
42. Attach wing brace
to front of wing frame assem-
blies with 3/4 x 2 hex bolts and 3/4 x 7 hex bolts
(inside plates, bottom holes) and (outside plate,
bottom outside hole, model 4000 only), 3/4 lock
washers and 3/4 nuts.
43. Attach wing frame assemblies to center frame
with the wing hinge pins , 1 1/4 flat washers
(rear side of wing hinge tubes only, do not use on
wing brace bar) and 1 lock nuts.
44. Attach front and rear wing stops to plates on
wing frame assemblies with 5/8 x 1 1/2 hex bolts
, 5/8 lock washers and 5/8 nuts.
45. On models 4000, attach base end of fold cylinders
to wing frame assemblies with 1 x 3 1/8 pins
, 1.5 x 1.00 x.075 machine washer and 3/16 x 2
cotter pin.
46. Do not hook up rod end of fold cylinders until sys-
tem is purged of air. See “Purging Hydraulic Sys-
tem” on page 23.
47. Bolt may be tightened to specs, See “Torque Values
Chart” on page 35.
1
4 2
3
4 5
6 7
8 9
4
10
11 4
12 13
11
Figure 11
Inside Wing, Brace Bar & Fold 42880
6
11
3
8
U
D
F
B
L
R
7
4
1
3
2
10
5
9
10
13
12