Great Plains 4000TM Predelivery Manual - Manual (Page 13)

Great Plains Manufacturing, Inc. Assembly 9
03/19/2014 586-537Q
Valve Brackets & Hoses
Refer to Figure 7
Note: The hoses will be shipped hooked up to valves and cyl-
inders. The front valves and hoses (that will need rout-
ed through front brace bar, trusses and up hitch to
tractor) will be rolled up and tied to front of center frame
during shipping. The bypass
and lock valves will
need mounted in proper location as shown and hoses
routed correctly before front trusses
and hitch are in-
stalled so front weight kits may be installed or removed
without taking hoses or valves loose. The hoses need
to route in locations shown with arrows, on top of wing
brace
to outside of tubes then back to inside. Install
front trusses on top of hoses as shown. Set them 1
11/16” (bypass valve bracket) and 3” (lock valve brack-
et) from truss plates as shown. See “Valve Brackets &
Valves” on page 8 for proper mounting instructions.
.
1
2
Figure 7
Valve Brackets & Hoses
42867
3
3
4
1 2
3
4
3