Great Plains 3S-3000HDF Operator Manual v2 - Manual (Page 65)

Great Plains Manufacturing, Inc. Table of Contents Index Adjustments 61
2014-02-11 Table of Contents Index 195-068M
Marker Disk Adjustment
Sharp Object Hazard:
Marker disks may be sharp. Use caution when making adjust-
ments in this area.
Mark Width
Refer to Figure 63
is the direction of travel.
To change angle of cut, and the width of the mark, loosen
1 ⁄
2
-inch bolts holding the disk assembly.
For a wider mark , increase the angle of the marker
with respect to the tube . For a narrower mark ,
reduce the angle.
Tighten bolts .
Direction of Cut
To have the marker throw dirt out, invert the disk on the
spindle, and invert the disk assembly.
FigureSpacer
Figure 63
Marker Disk Angle
11757
T
2
1
N
W T
T
2
W
1 N
FigureSpacer
Figure 64
Marker Disk Inverted
11248
T
2